01
Check what’s included
Make sure your display, LED cable, remote, mounting hardware, and any included accessories are inside the package. Keep the packaging until setup is complete.
Acrylux owner guide
Your display is here.
Follow these quick steps to unbox, set up, and get the best look from your Acrylux LED acrylic display.
First steps
Before mounting your poster, check the package and test the LEDs.
02
Remove protective film
Some acrylic pieces may have a protective film. Peel it off slowly from the corner before displaying your poster. Avoid using sharp tools directly on the acrylic.
03
Plug it in before mounting
Connect the poster to power and confirm the LEDs turn on before placing it on your wall. This makes setup easier and helps catch any issue early.
Set up
Use this section for mounting, cable routing, remote instructions, power bank instructions, and cleaning tips.
1
step 1
Pick the right spot
Choose a clean, dry wall near a power source, if you decide to use the battery box, you have the freedom of placing it wherever you'd like.
2
step 2
Mark the screw holes
Using the supplied hole auxillary paper, hold the poster where you want it, make sure it is level, then lightly mark the screw hole locations on the wall.
3
step 3
Install the screws
Install the supplied screw anchors into the marked spots, followed by the screw. Leave a small gap between the screw head and the wall so the poster can sit securely on the mounts.
4
step 4
Hang the poster carefully
Line up the mounting holes with the screws and gently place the poster onto the wall. Do not force it or pull on the acrylic. If this is too tricky, you can also directly mount the aluminum rail onto the screws
5
step 5
Pair the remote
Before using the lights, the remote and controller need to be paired. After powering on the poster, press and hold both the ON and lower brightness buttons at the same time within the first 3 seconds. The LED strip will flash once pairing is successful. Each remote is paired to one controller only.
Please note, you can leave the remote unpaired to control all posters at the same time. However, this may cause the poster(s) to shut off/on randomly.
6
step 5
Enjoy!
That is it! Now you have a unique piece of art that is sure to bring lots of attention. Thank you for your support!
Enjoying your poster?
Reviews help a small Canadian brand grow.